Cross Hatch Cutter Adhesion Test Kit – CC1000 Range

About Cross Hatch Cutter Adhesion Test Kit – CC1000 Range

The Cross Cut Adhesion Test Kit CC1000 is used to test the adhesion of dry coats of paint on their substrate by means of a series of cuts through the coating. Two series of parallel cuts cross angled to each other to obtain a pattern of 25 or 100 similar squares. The ruled area is evaluated by using a table chart after a short treatment with a stiff brush, or adhesive tape for hard substrates.

The round cutting knife of the Cross Cut Adhesion Test Kit CC1000 has eight cutting edges that can be changed easily by rotating the knife. The self positioning knife bracket of the Cross Cut Adhesion Test Kit (CC1000) ensures equal pressure on the cutting knife.

Directions for use:

Simply make a cutting pass through the coating to the substrate; this will leave 6 parallel cuts in the coating. Then make a second pass at 90º to the first to make a square lattice pattern.  Apply a length of adhesive tape over the lattice pattern & remove tape within 5 minutes.  You can then classify the test area using the supplied magnifier to the relevant national standard.

Applications

• Testing adhesion of dry coats of paint on substrates

Specifications

ISO 2409:

• 1 mm spacing for coatings up to 60 µm on hard substrates
• 2 mm spacing for coatings up to 60 µm on soft substrates
• 2 mm spacing for coatings from 61 to 120 µm on both hard and soft substrates
• 3 mm spacing for coatings from 121 µm to 250 µm on both hard / soft substrates

ASTM D3359:

• 1 mm spacing for coatings up to 50 µm
• 1.5 mm spacing for coatings from 50 to 125 µm

Packing List:

• Cross Hatch Adhesion Tester with Round Head Cutting Knife
• Brush
• Illuminated Loupe
• Roll of Adhesive Tape to ISO 2409

All Downloads

Filename	Size	Download
Cross Hatch Adhesion Tester CC1000 Range Product Data Sheet	0.23MB

Ordering Information

A range of accessories is available for this product:

01543411460	[email protected]