Cross Hatch Cutter Adhesion Test Kit – CC2000 Basic Range

About Cross Hatch Cutter Adhesion Test Kit – CC2000 Basic Range

The Cross Hatch Adhesion Test is used to test the adhesion of dry coats of paint on their substrate by means of a series of cuts through the coating. Two series of parallel cuts cross angled to each other to obtain a pattern of 25 or 100 similar squares. The ruled area is evaluated by using a table chart after a short treatment with a stiff brush, or adhesive tape for hard substrates.

The cutting knife of this Cross Hatch Adhesion Test Cutter is easy to exchange without the use of extra tools and having a self positioning knife bracket ensures equal pressure on the cutting knife.

Directions for use:

Simply make a cutting pass through the coating to the substrate, this will leave 6 parallel cuts in the coating. Then make a second pass at 90º to the first to make a square lattice pattern.  Apply a length of adhesive tape over the lattice pattern & remove tape within 5 minutes.  You can then classify the test area using the supplied magnifier to the relevant national standard.

Applications

• Testing adhesion of dry coats of paint on substrates

Specifications

ISO 2409:

• 1 mm spacing for coatings up to 60 µm on hard substrates
• 2 mm spacing for coatings up to 60 µm on soft substrates
• 2 mm spacing for coatings from 61 to 120 µm on both hard and soft substrates
• 3 mm spacing for coatings from 121 µm to 250 µm on both hard / soft substrates

ASTM D3359:

• 1 mm spacing for coatings up to 50 µm
• 1.5 mm spacing for coatings from 50 to 125 µm

Packing List (kit only):

• Cross Hatch Adhesion Tester with Round Head Cutting Knife
• Brush
• Illuminated Loupe
• Roll of Adhesive Tape to ISO 2409

All Downloads

Filename	Size	Download
Cross Hatch Adhesion Tester CC2000 Range Product Data Sheet	0.31MB

Ordering Information

A range of accessories is available for this product:

01543411460	[email protected]